Adjustable Angled Risers (Basebar)

Ā£150.00

šŸ”—Ā Compatibility Guide
šŸ”—Ā Install Guide

IF ORDERING TO USE WITH ANEMOI MK1 EXTENSIONS, PLEASE ADVISE IN YOUR ORDER NOTES.

A fully adjustable angled riser, offering micro angle adjustment from 10 degrees through to 30 degrees. When used in isolation, the basebar riser will only adjust the angle of your armrests. Pair with one of our pole clamp options to adjust the angle of your extension poles.

This product is compatible only with WattShop components:
ā€¢ Anemoi Basebar
ā€¢ Anemoi Mount Plates
ā€¢ Mono Brackets
ā€¢ Conversion Spacers

For direct mount options, please refer to our universal adjustable riser.

Ā 

Product Description

The riser uses two M5 threaded holes at 40mm centres instead of the slot design of the universal riser. Barrel nuts are not required.

This design makes stack height and cable routing adjustments, specifically with the Anemoi basebar much quicker and easier. The design retains the ability to route shifter cables internally.

The riser is manufactured from machined 7075-T6 aluminium and is anodised black. The upper component is laser etched with 5-degree denominations whilst the lower component is notched to indicate degree angle.

UCI regulations allow up to a 30 degree riser angle - this is the maximum angle the riser allows for.
Technical Specifications

WEIGHT

Adjustable Risers: 96g (pair)

HARDWARE

- 2x risers (each riser has an upper and lower part)
- 4x retaining nuts (2x front and 2x rear)
- 4x M5x16mm grubs screws
- 4x anti-vibration washers
- 2x M5x18mm low cap head bolts
- 2x M5x25mm low cap head bolts

Alternatively if specified for use with our Anemoi extension system you will receive 2x M5x25mm cap head bolts and 2x M5x35mm cap head bolts instead of the M5x18mm and M5x25mm cap head bolts.