Anemoi Adjustable Angled Riser
Anemoi Adjustable Angled Riser
Anemoi Adjustable Angled Riser
Anemoi Adjustable Angled Riser
Anemoi Adjustable Angled Riser
Anemoi Adjustable Angled Riser
Anemoi Adjustable Angled Riser

Anemoi Adjustable Angled Riser

Regular price £140.00

A fully adjustable and universally fitting angled riser, offering micro angle adjustment from 5 degrees through to 25 degrees. Mounting directly to on top of your existing pole clamp to angle your armrests or with your existing pole clamp removed they can be mounted to the top of your riser stacks and in combination with our universal pole clamps they will angle both your armrests and extension poles.

Universally compatible for both bolt down and bolt up systems in either M5 or M6. Our adjustable risers come supplied with either M5 or M6 barrel nuts for bolt up mounting. Please note you will require a dual riser stack system with a flat top riser stack and fore-aft bolt centres between 15-40mm. 

The riser is manufactured from machined 7075-T6 aluminium and is anodised black. The lower component is laser etched with 1-degree denominations whilst the upper component is notched to indicate degree angle.

Our adjustable risers have a through hole and channels on the side for internal cable routing, covering various different cable routing options. This provides clean routing when used with our extension system or with your own riser stack.

If you need to be UCI compliant you will need to ensure the angle is set no greater than 15 degrees. When used in combination with our Anemoi Aero Extension system, doing so will also ensure compliance with the UCI 10cm rule.

These risers as a standalone component will only adjust the angle of your armrests, whilst also being compatible with our Anemoi Aero Extension System.

Removing your current pole clamps and pairing these with our universal pole clamps will allow you to angle either just your armrests or both your armrests and extension poles depending on whether our universal pole clamps are mounted above or below the adjustable angled riser in the stack.

Unsure of compatibility with your specific base bar then check out our compatibility check which can be found here.

HARDWARE

The risers come supplied as pair. Each pair has an upper and lower part that interface, 4x retaining nuts (2x front and 2x rear), 4x M5x16mm grub screws, 4x anti-vibration washers, 2x M5x18mm low cap head bolts, 2x M5x25mm low cap head bolts, 4x M5 or M6 barrel nuts. Barrel nuts are for bolt up mounting (if required).

Also supplied are 4x M5x16mm countersunk head bolts (for use when paired with universal pole clamps).

WEIGHT

  • Adjustable Risers: 96g (pair)
  • Universal Pole Clamps: 81g (pair)

 

Customer Reviews

Based on 1 review Write a review