Adjustable Angled Risers (Universal)

A fully adjustable and universally fitting angled riser, offering micro angle adjustment of your armrests from 10 degrees through to 30 degrees. The adjustable riser mounts directly on top of your existing pole clamp to angle your armrests.

Alternatively, mount onto your riser stacks and pair with our Universal or Inline Pole Clamps to angle both your armrests and extension poles.
Please note our Universal and Inline Pole Clamps are sold separately.

Universally compatible for both bolt down and bolt up systems in either M5 or M6, our adjustable risers come supplied with either M5 or M6 barrel nuts for bolt up mounting. Please note you will require a dual riser stack system with a flat top riser stack and fore-aft bolt centres between 15-40mm.

Our adjustable risers have a through hole and channels on the side for internal cable routing, covering various different cable routing options. This provides clean routing when used with our extension system or with your own riser stack.

The riser is manufactured from machined 7075-T6 aluminium and is anodised black. The upper component is laser etched with 5-degree denominations whilst the lower component is notched to indicate degree angle.

UCI regulations allow up to a 30 degree riser angle - this is the maximum angle the riser allows for.

Removing your current pole clamps and pairing these with our universal pole clamps will allow you to angle either just your armrests or both your armrests and extension poles depending on whether our universal pole clamps are mounted above or below the adjustable angled riser in the stack.

Unsure of compatibility with your specific basebar? Check out our compatibility chart.

WEIGHT

Adjustable Risers: 96g (pair)
(ADD ON) Universal Pole Clamps: 81g (pair)
(ADD ON) Inline Pole Clamps: 162g (pair)

HARDWARE

- 2x risers (each riser has an upper and lower part)
- 4x retaining nuts (2x front and 2x rear)
- 4x M5x16mm grubs screws
- 4x anti-vibration washers
- 2x M5x18mm low cap head bolts
- 2x M5x25mm low cap head bolts
- 4x M5 or M6 barrel nuts. Barrel nuts are for bolt up mounting (if required)

If purchased with the universal pole clamps you will also receive:
- 4x M5x16mm countersunk head bolts

If purchased with the inline pole clamps you will also receive:
- 4x M5x25mm countersunk head bolts
- 2x M5x35mm low cap head bolts (instead of the M5x18mm low cap head bolts)

Please note we recommend against using the universal adjustable riser with 3rd party direct mount extensions.